Hi,
I am on NCM 7.1.1 and I noticed the same thing. However, I think if you are looking at the "Config Summary" page and clicking on the "Change Report", the top of the change report should provide the last a time stamp on when last a report was changed and by who. Most times when I see the lines that seem to have changed it shows that its just a spacing thing and the shows the corresponding added line on the other side. Note in the 2 examples, on the second one there was a power outage so technically there wasn't a configuration change but now in the config it no longer had the last person that made a change, it just states there have been no changes since last restart.
| ! | ! | |
| Image may be NSFW. Clik here to view.  | ! Last configuration change at 22:50:20 UTC Thu Sep 4 2014 by xyzuser | ! Last configuration change at 19:11:03 UTC Wed Sep 10 2014 by xyzuser |
| Image may be NSFW. Clik here to view. | ! NVRAM config last updated at 21:37:15 UTC Thu Sep 4 2014 by xyzuser | ! NVRAM config last updated at 19:11:04 UTC Wed Sep 10 2014 by xyzuser |
| ! | ! | |
| version 15.0 | version 15.0 | |
| no service pad | no service pad | |
| BEFORE | AFTER | |
| Last Week - 9/5/2014 1:48:55 PM | ADDS 0, DELETES 1, CHANGES 1 | |
| ! | ! | |
| Image may be NSFW. Clik here to view. | ! Last configuration change at 15:25:45 CST Wed Jun 11 2014 by svc_swconfigmgr | ! No configuration change since last restart |
| Image may be NSFW. Clik here to view.  | ! NVRAM config last updated at 15:26:43 CST Wed Jun 11 2014 by svc_swconfigmgr | |
| ! | ! | |
| version 12.2 | ||
You may just need to explain to them that its the way the NCM downloads the configs.
Regards,
Ose
